0 Members and 1 Guest are viewing this topic.
How are you gonna connect to that smooth slipery shaft??
Yummi perverts it.....
It's what I do. I have no real skill in the buggy world so poking fun at folks is my only contribution. No worries, the dirty thoughts will come back to you soon enough.
OK first off. I was just pointing out that it was a polished shaft. That was the first clean thought I had today, and Yummi perverts it.....You do need something like Rick has. The shaft would probably be strong enough, but welding to it will not hold. The problem is the Cv's that Whiplash is using have splined shafts on them, not flanges. Did you buy 4 complete halfshafts to get those CV's Whiplash? I have been thinking about this some myself.Are you going to go 5-link in the rear to keep away from plunge?You could cut the shafts off of two of the CV's and weld flanges on, but I am guessing that the CV OD's are larger than a 930 CV bolt pattern which will make it very ugly.I have been looking at those CV's, Is there a seal or something that you need in addition to the half shaft, and F-150 bearing hub?I had an idea of how to handle the center using those CV's, but I wanted to try it myself before throwing it out to the public. Anyway I attached a PDF of the concept. I just don't want someone to try it not understanding that it isn't tested. I have already got some feedback on the idea, and the biggest problem is probably holding it from only one side.