Author Topic: New Car in Aus  (Read 13959 times)

0 Members and 1 Guest are viewing this topic.

Offline Simon

  • Fabricator
  • **
  • Posts: 142
Re: New Car in Aus
« Reply #105 on: February 14, 2016, 03:16:38 PM »
No problems, there is no secrets there. There is a support bearing and a seal. I use a sealed bearing and the lip seal is on the inside. I couldn't find a bearing that was rated for crank RPM (Max I could find was 10000 RPM), so my line of thinking was that if the bearing died, the seal would stop crap getting into my motor.

To fit I bore out the center of the stator cover and drill the the stator hold bolt holes all of the way through and finish tapping them. My support bearing then bolts into these holes from the other side if that makes sense.

Offline fabr

  • Administrator
  • *
  • Posts: 91571
Re: New Car in Aus
« Reply #106 on: February 14, 2016, 04:01:20 PM »
I think I understand . Thanks.
"There can be no divided allegiance here.  Any man who says he is an American,
but something else also, isn't an American at all.  We have room for but one
flag, the American flag... We have room for but one language here, and that is
the English language... and we have room for but one sole loyalty and that is a
loyalty to the American people."
Theodore Roosevelt 1907

-----------------------------------------------------------
"I fear the day that technology will surpass our human interaction. The world will have a generation of idiots" Albert Einstein  (IT'S OFFICIAL THAT DAY IS HERE NOW!)