DTSFab.com (Desert, Trail and Sand)
UTV's Off Road ( RZR, YXZ, Mini Buggy, Carts,etc.) => UTV Motor and Drivetrain => Topic started by: Tivie on December 12, 2010, 09:43:40 AM
-
I purchased a billet oil pan to gain some clearence, and realized when I received it it wasn't plumbed for the oil cooler. Can I just drill and tap for AN fitting, or do without the oil cooler. The motor is a Busa, buggy is a Cuda.
Thanks
-
IMO the oil cooler is needed but many do away with it. IMO a bad idea. I don't know of what pan you have but it depends on it what needs done to use the cooler with it.
-
I found it on the internet. It is a RPM logo on the bottom.
-
I have the same one, I will be machining the ports to use the original cooler return line.
-
I built five of these for a guy one time. He never did sale them. All the hot racer's said that they weight to much. He runs a hot dog bike and had to pull the pan after every run to change the bent forks because of the air shifter. This let him just pull a window out and change out the forks instead of putting a new gasket on every time.