0 Members and 16 Guests are viewing this topic.
Quote from: fabr on April 15, 2024, 02:13:25 PMThey have 1/8, 3/16 and 1/4. I used 3/16 but wish i had gone 1/4". At about 80 it begins pushing in..Thanks and good info.What was your made for? Looking on their site.
They have 1/8, 3/16 and 1/4. I used 3/16 but wish i had gone 1/4". At about 80 it begins pushing in..
No need to wet sand the edges. Dry is fine. I suggest at least 2 thickness masking tape on saw foot and 2 on the windshield just to be safe against scratches. HINT:Use ONLY sharp,ground teeth jig saw blades. Do not use fine tooth types either.Are you doing a glue in? I figured you would do a rubber mount. I pretty much had no choice but I think I would do the rubber mount again. I have some scrap material and will do a couple bends to see if the coating scratches/fractures.