0 Members and 1 Guest are viewing this topic.
Ok thanks !! I will read that thread so that we don't go into it again. The only CAD I have access to is to draw parts for my CNC machine. It doesn't animate.I plan on copying the geometry from the Barracuda, but all I have to go by is pictures. I have no dimensions. My buggy will only be about 65-70% the size of the Barracuda.I was going to draw the basic geometry first, and then try to fine tune the bump steer out of it while all the joints were just tacked.Thanks for the advice. Dan
I have never used any software that animates the parts, but by drawing them in an up, down and ride height position, you can get a good feeling for what the suspension will do as far as camber change through the travel, etc.