DTSFab.com (Desert, Trail and Sand)
UTV's Off Road ( RZR, YXZ, Mini Buggy, Carts,etc.) => UTV Controls and Electrical => Topic started by: Carlriddle on May 12, 2009, 02:16:30 PM
-
I need to move the reservoir from my brake mastercylinder. Looking for 45 or 90 that would screw into mastercylinder and into reservoir to "bump" it over about an inch or so. I saw one on somewhere ::), but cant find now. Its an Empi single master. Any thoughts??
-
1/8 pipe thread, i could have gotten you one with the harnesses really easy.... DOH!!
-
Needs to thread into large hole (I think?) about 1".
-
Doh, you did say reservoir, My bad...
-
www.speedwaymotors.com (http://www.speedwaymotors.com) has loads of break fittings. Give them a look. Did a quick search for fittings and got back 21 pages.
-
Ok here what I have and what I need to do. Or a new resivoir with a crooked neck would work too. ????
-
What is obstructing it?
-
Front frame. I wanted to slide pedal assem forward to gain couple more inches leg room. Being 6'4" kinda stinks, but only sometimes. Got to move seat angle some, that might take care of some legroom problems since they dont seem to make what I am after.