DTSFab.com (Desert, Trail and Sand)

Automotive Powered Off Road (AKA: Buggys, Jeeps, Trucks, Etc,Etc. ) => "AP" Member Project Logs => Topic started by: Punkur67 on February 20, 2011, 06:53:13 PM

Title: Cut the engine cage off
Post by: Punkur67 on February 20, 2011, 06:53:13 PM

Well after a couple years of looking at my not so attractive engine cage I finally choped it off. Still need to add a wing up top to hold a few oval LED lights. Also re-routing the coolant lines. I fliped the crossover tube and ordered some silicone 90s to help clean the lines up. The old coolant lines are still in the pics.

Title: Re: Cut the engine cage off
Post by: Punkur67 on February 20, 2011, 07:01:23 PM

Here is the ugly old cage

Title: Re: Cut the engine cage off
Post by: trans man on February 20, 2011, 08:27:17 PM

IMO That looks better. 8) 8) 8)

Title: Re: Cut the engine cage off
Post by: Punkur67 on February 20, 2011, 11:54:31 PM

The old one looked beter in my head than on the car. I was too much in a hurry to change it after it was welded up. I shure am glad I cut it off though.

Title: Re: Cut the engine cage off
Post by: Carlriddle on February 21, 2011, 05:55:15 AM

Nothing better than a rear end with nice curves. rofl  Looks good

Title: Re: Cut the engine cage off
Post by: sandycrack on February 21, 2011, 08:11:31 PM

looks really good!

Title: Re: Cut the engine cage off
Post by: Punkur67 on March 06, 2011, 12:55:38 AM

Here are some updated pics. I still need to wire and sand the wing. Also finished the new coolant lines. I am sooooooooo haappy i decided to change the rear.

Title: Re: Cut the engine cage off
Post by: trans man on March 06, 2011, 06:26:00 PM

Lookin Good ;D ;D ;D