« previous next »
Pages: [1]   Go Down

Author Topic: idler bearings  (Read 1602 times)

0 Members and 1 Guest are viewing this topic.

Offline Voodoochikin04

  • Vip Eye candy Supplier!!
  • VIP
  • *
  • Posts: 1757
idler bearings
« on: May 10, 2009, 02:04:23 PM »
soo.. what if someone took one of the bearings that you guys use for wheel stubs and axles shafts, and put it in an idler sprocket..  would it handle just fine?
Logged
"it's only when you have lost everything, that your free to do anything"

Admin

  • Guest
Re: idler bearings
« Reply #1 on: May 10, 2009, 02:56:40 PM »
2 of them with a decent spread between them may...
Logged

Offline Voodoochikin04

  • Vip Eye candy Supplier!!
  • VIP
  • *
  • Posts: 1757
Re: idler bearings
« Reply #2 on: May 10, 2009, 03:27:29 PM »
so like a 15 tooth sprocket welded to a small short shaft with bearings on either side?
Logged
"it's only when you have lost everything, that your free to do anything"

Admin

  • Guest
Re: idler bearings
« Reply #3 on: May 10, 2009, 03:29:05 PM »
If i wanted it to last id use a larger sprocket and larger bearings and shaft....
Logged

Offline Voodoochikin04

  • Vip Eye candy Supplier!!
  • VIP
  • *
  • Posts: 1757
Re: idler bearings
« Reply #4 on: May 10, 2009, 03:32:33 PM »
ok 17tooth, and 1" id bearings?
Logged
"it's only when you have lost everything, that your free to do anything"

Offline Punkur67

  • Hero Member
  • ****
  • Posts: 827
Re: idler bearings
« Reply #5 on: May 10, 2009, 11:19:12 PM »
the bigger the sprocket the slower the bearings will spin
Logged
Its better to be a smartass than a dumbass!
Pages: [1]   Go Up
« previous next »
 
SimplePortal 2.3.7 © 2008-2024, SimplePortal