DTSFab.com (Desert, Trail and Sand)

Machinery, Trailers, Toyhaulers and Motorhomes => Machinery Builds => Topic started by: Punkur67 on January 30, 2011, 08:16:06 PM

Title: Started a billet thermostat housing for the fairlane
Post by: Punkur67 on January 30, 2011, 08:16:06 PM

We started making a billet t-stat housing today with my friends 3 axis cnc machine. This block was the first one we did. The zero was off when we fliped it over so this one is junk. Should have the completed one in the next couple days. It is amazing what you can make with these things.

Title: Re: Started a billet thermostat housing for the fairlane
Post by: fabr on January 30, 2011, 09:16:26 PM

Quote from: Punkur67 on January 30, 2011, 08:16:06 PM

We started making a billet t-stat housing today with my friends 3 axis cnc machine. This block was the first one we did. The zero was off when we fliped it over so this one is junk. Should have the completed one in the next couple days. It is amazing what you can make with these things.

;D ;D ;D ;D

Title: Re: Started a billet thermostat housing for the fairlane
Post by: Engineer on January 31, 2011, 08:42:13 AM

Two setups, start with at least one extra part.

Three setups, start with at least two extra parts.

If there is only one setup then you just cut extras as you screw them up.


 ;)