DTSFab.com (Desert, Trail and Sand)
Automotive Powered Off Road (AKA: Buggys, Jeeps, Trucks, Etc,Etc. ) => Motor and Drivetrain => Topic started by: fabr on August 12, 2011, 07:21:47 PM
-
Sheesh! No wonder there's such a limited choice in shifters for a mid engine/rear VW 091 tranny !!! What a PAIN!!!!!!!
It ain't pretty but it works. eyes I had to fab one from scratch since the chassis prevented using anything available. I swear,if this busa/091 adapter fully pans out as it seems it is ,I'm building a hydraulic shifter patterned after the one Fast had on his Mendi. Much simpler. This is BS at best running 2 fricken cables as has to be done to get a push/pull and a rotational action. Oh well,it will work fine for the use it will see. A few pics.
-
Looks good. 8) 8) 8)
How many hours do you have in that shifter?
-
LOL!!!! 20 thumb down
-
not to bad and if it works then great!
-
Sees to work fine just sitting here. Just sitting ALWAYS makes shiftjng more difficult but cable routing, and need for push/pull as well as rotational motion needed, makes these things BS at best tho.
-
But at least you will have a reverse now. 8) 8) 8)
-
And an underdrive also!
-
Good thing Purple M&M thinks in 3D
And has a personal chef to keep him nutriented rofl
-
I think more in BS than 3D! LOL!!!!