DTSFab.com (Desert, Trail and Sand)
The DTS Trader => General Classifieds => Topic started by: Bennyhanna on August 19, 2011, 06:15:19 PM
-
My father owns a machine/fab shop, I try to run the machining side while my brother runs the fab side. We are making room for a new machining center, getting rid of some mills we don't use. I will get more details if anyone shows any interest. Located in indianapolis. First is I believe an early 80's eagle with an aniliam crusader control, dinosaur. We are asking 2k for this. It needs some work on the head, it is basically a bridgeport j head and one shaft has sheared the keyway. This is good for home machinists because the servos can be turned off and it can be run as a manual with digital readouts. Next machine is a wells-index with a general numeric control, which is basically like an early fanuc. This has a mister activated with an m-code. This comes with between 10-20 tool holders and a set of collects. Asking 4k. Both have, I believe, Ericsson quick change chucks on the spindles. I will load machines on your trailor for free, of course. Have all manuals. Many more details upon request.
-
Is that 4k for the two of them? ;D
-
negative.
-
Can't blame a bloke fa try'n.. ;D ;)