DTSFab.com (Desert, Trail and Sand)

The DTS Trader => General Classifieds => Topic started by: SPEC on November 03, 2009, 05:32:29 AM

Title: Billet hubs
Post by: SPEC on November 03, 2009, 05:32:29 AM

Next to go is.....
My custom CNCed billet hubs...They are 7076 billet, with sealed bearings dual bolt pattern ;D 4 on 144 AND 4 on 156 so all atv wheels will fit these...no more searching for the right wheel to fit your hubs...these are extremely light weight...at only 2 pounds 6 oz each with the bearings :o
the bearings fit a standard 250R honda spindle or my uprights
I'll let these go for 200 bux plus shipping

Title: Re: Billet hubs
Post by: Reidy02 on November 06, 2009, 03:42:03 AM

Man they look the bizz Spec..

Title: Re: Billet hubs
Post by: jwcarguy on December 05, 2009, 09:06:18 PM

What are the bearing specs.?
Trying to see if I could swap out the hubs on the front of my Triple EEE.

Thanks, Jeff

Title: Re: Billet hubs
Post by: SPEC on December 06, 2009, 06:06:05 AM

I'm looking for my calipers ::)
Snout length is 2.625 and the diameter is...I'm saying off of memory 3 years ago I believe is .749

Title: Re: Billet hubs
Post by: SPEC on December 06, 2009, 07:16:44 AM

Sorry Jeff
 they are
 snout specs are...2.625" x .780"

Title: Re: Billet hubs
Post by: jwcarguy on December 06, 2009, 12:55:09 PM

Thanks, Spec!!
I will tear mine apart and measure them.

Title: Re: Billet hubs
Post by: SPEC on May 25, 2010, 06:53:36 AM

I still have 2 pair of these...
I'll let them go for 150 a pair...complete

Title: Re: Billet hubs
Post by: SPEC on October 15, 2010, 07:41:14 AM

Only 1 pair left...And I'm not moving them to Kansas