« previous next »
Pages: 1 2 [3]   Go Down

Author Topic: Drilling wheels  (Read 5999 times)

0 Members and 1 Guest are viewing this topic.

Rick S.

  • Guest
Re: Drilling wheels
« Reply #30 on: March 15, 2009, 09:12:02 AM »
I agree you need to use a mill. I would clamp the wheel to the table then pick up the holes one at a time by carefully dropping in first with a collet mounted dowel pin.
I'd use a single flute c'sink and run it slow 60rpm using WD40 or oil.   
Logged

Offline fabr

  • Administrator
  • *
  • Posts: 93167
Re: Drilling wheels
« Reply #31 on: March 15, 2009, 10:52:08 AM »
Ditto.
Logged
"There can be no divided allegiance here.  Any man who says he is an American,
but something else also, isn't an American at all.  We have room for but one
flag, the American flag... We have room for but one language here, and that is
the English language... and we have room for but one sole loyalty and that is a
loyalty to the American people."
Theodore Roosevelt 1907

-----------------------------------------------------------
 " You have all the right in the world to believe any damn thing you'd like, but you don't have the right to demand that I agree with your fantasy"
Pages: 1 2 [3]   Go Up
« previous next »
 
SimplePortal 2.3.7 © 2008-2024, SimplePortal