0 Members and 1 Guest are viewing this topic.
Even a mean sloped drive can be compensated for with the right adjusting feet. The bender requires bolts to stick up from the floor and or sunken anchors to screw bolts into. As for the middle of a two car garage.... Gonna be TIGHT. Even a 2.5 nmight be tight. You will likely need to favor one side so that the tube being bent has somewhere to go.The handle has to stick out one side over four plus feet (unless you go Hydraulic) and the other side will need enough room for whatever length you decide to bend. Being you need the other tools mounted yah might consider just making a moveable bench with it all on it lol.
I think he was hinting that his drive is at a steep slope. The one on rollers might not work too well for him.
This is what I'mgoing with next. Bends vertical, is mobile and no leaning down. Used Pro-tool 105 dies, air hydraulic or manual. http://www.probender.com/products.asp?cat=15