DTSFab.com (Desert, Trail and Sand)
Automotive Powered Off Road (AKA: Buggys, Jeeps, Trucks, Etc,Etc. ) => Motor and Drivetrain => Topic started by: Punkur67 on November 25, 2008, 06:10:31 PM
-
Does anybody know the length difference between a 002 and 091. I think its 1" but is it on the nose cone side or bellhousing side of the drive flanges.
-
Dunno.Try The Samba site.I'm sure they can tell ya.
www.thesamba.com
-
Ask Don at the Bus Box? :laugh:
Better, send a PM to AZ Transaxle? They are here as a sponsor on the site and might be able to help with this question?
http://dtsfab.com/index/index.php?topic=474.0 (http://dtsfab.com/index/index.php?topic=474.0)
-
Ask Don at the Bus Box? :laugh:
ROFL Now that's funny Yummi. :m
-
I'm sure Don would tell you but the question is -could you TRUST him? ;D
-
And will he measure to the bellhousing or to all the crap he left on it.
-
ask az transaxle, im sure he can tell you...
-
And will he measure to the bellhousing or to all the crap he left on it.
Funny as hell,not very fair,but I gotta admit I'm laughing my ass off.
-
Brainfart, I didnt even catch onto that...
-
the intermediate housing (the one between the nose cone and the main case) is 5/16 thicker on the 091 and the bellhousing is an additional 1/8.
The 002 bell housing can be bolted right on an 091 if you need it to be shorter. The starters are different as well. We get a lot of requests for an 091 with an 002 bellhousing so the customer can use the more common starter.
-
Thank you az