rear bearings

[SandDragon]

Hey does anyone have a diagram for installing rear bearings and stubes in my new 3x3 trailing arms the last time I had the old stock trailing arms to use as a guide this time all I have is a bunch of new parts and would like to look at a exploded assembly diagram.

Thanks

[dsrace]

don't have a diagram but it's pretty simple. on the inside you'll press in you ball bearing, bearing then install the snap ring and grease seal. from the out side you'll drop in you tube spacer then push in the barrel bearing and it's sliding inner race then the cap plus gasket goes on over the disc brake mount and don't forget the spacer that go between the stub and bearings too.

[SandDragon]

thanks I kind of figured it out than also found out I didn't have the snap rings I look all over town and no one has them, I guess I'm going to have to order one off the net. Just my luck I get an extra day off and I didn't get anything done. Thanks for the help.

[fabr]

thanks I kind of figured it out than also found out I didn't have the snap rings I look all over town and no one has them, I guess I'm going to have to order one off the net. Just my luck I get an extra day off and I didn't get anything done. Thanks for the help.

effin' Murphy's Law!

[trans man]

Sometimes it goes that way.