0 Members and 1 Guest are viewing this topic.
OK guys I need some more help how do you tighten the rear axle nut and hold the hub at the same time? How tight should it be and how do you check it? another question when you have the axles in and you move the trailing arm up and down there is a point when the axle is at its shortest point how much play should there be in the axle back and forth? I'm also guessing that that little bag of grease is enough for one CV it doesn't look like much to me.Thanks
Thanks for the help the only problem is the .5 to .65 in axle play I believe it is more like .25 to .375 I can put another washer behind the trailing arm bushing to get a little more room but it doesn't give much more than a 1/4" of thread depth in my pivot bolt but I will be using safety wire to keep it from backing out. thanks again trying to do this right the first time.
275 foot lb's. big cheater bar on the ratchet handle.