« previous next »
Pages: [1]   Go Down

Author Topic: Billet hubs  (Read 2389 times)

0 Members and 1 Guest are viewing this topic.

SPEC

  • Guest
Billet hubs
« on: November 03, 2009, 05:32:29 AM »
Next to go is.....
My custom CNCed billet hubs...They are 7076 billet, with sealed bearings dual bolt pattern ;D 4 on 144 AND 4 on 156 so all atv wheels will fit these...no more searching for the right wheel to fit your hubs...these are extremely light weight...at only 2 pounds 6 oz each with the bearings :o
the bearings fit a standard 250R honda spindle or my uprights
I'll let these go for 200 bux plus shipping
Logged

Offline Reidy02

  • VIP
  • *
  • Posts: 1534
  • What goes around comes around!
Re: Billet hubs
« Reply #1 on: November 06, 2009, 03:42:03 AM »
Man they look the bizz Spec..
Logged
VTR 1000 CUDA on the way.. What goes around comes around!!

jwcarguy

  • Guest
Re: Billet hubs
« Reply #2 on: December 05, 2009, 09:06:18 PM »
What are the bearing specs.?
Trying to see if I could swap out the hubs on the front of my Triple EEE.

Thanks, Jeff
Logged

SPEC

  • Guest
Re: Billet hubs
« Reply #3 on: December 06, 2009, 06:06:05 AM »
I'm looking for my calipers ::)
Snout length is 2.625 and the diameter is...I'm saying off of memory 3 years ago I believe is .749
Logged

SPEC

  • Guest
Re: Billet hubs
« Reply #4 on: December 06, 2009, 07:16:44 AM »
Sorry Jeff
 they are
 snout specs are...2.625" x .780"
Logged

jwcarguy

  • Guest
Re: Billet hubs
« Reply #5 on: December 06, 2009, 12:55:09 PM »
Thanks, Spec!!
I will tear mine apart and measure them.
Logged

SPEC

  • Guest
Re: Billet hubs
« Reply #6 on: May 25, 2010, 06:53:36 AM »
I still have 2 pair of these...
I'll let them go for 150 a pair...complete
Logged

SPEC

  • Guest
Re: Billet hubs
« Reply #7 on: October 15, 2010, 07:41:14 AM »
Only 1 pair left...And I'm not moving them to Kansas
Logged
Pages: [1]   Go Up
« previous next »
 
SimplePortal 2.3.7 © 2008-2024, SimplePortal