Login
Register
Username:
password:
X
Welcome to the new DTSFab.com
Home
Forum
Help
Recent posts
Login
Register
DTSFab.com (Desert, Trail and Sand)
»
Automotive Powered Off Road (AKA: Buggys, Jeeps, Trucks, Etc,Etc. )
»
Motor and Drivetrain
»
CV, axle, hub, bearing pictures
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: CV, axle, hub, bearing pictures (Read 2006 times)
0 Members and 1 Guest are viewing this topic.
LiveWire
Guest
CV, axle, hub, bearing pictures
«
on:
May 16, 2011, 09:35:50 AM »
Hubs are 5 on 4.5, 33 spline. 5/16" thick laser cut plate to weld into suspension uprights. 28" 28 spline axles. About 18" from straight out to CV binding on axles.
These are the 'F-150' CVs people have talked about. The hubs also work with EMPI 930 micro stubs which would in turn use the same axles.
«
Last Edit: May 18, 2011, 08:43:00 AM by LiveWire
»
Logged
LiveWire
Guest
Re: CV, axle, hub, bearing pictures
«
Reply #1 on:
May 16, 2011, 09:38:04 AM »
If those axles are overkill:
5 on 4.5 hubs, 26 spline, 20" 25 spline axles. About 13.5" from straight out to axle bind.
Logged
LiveWire
Guest
Re: CV, axle, hub, bearing pictures
«
Reply #2 on:
May 16, 2011, 09:39:42 AM »
With 4 bolt pattern instead:
Bearing carrier is a bit more complicated.
Logged
LiveWire
Guest
Re: CV, axle, hub, bearing pictures
«
Reply #3 on:
May 16, 2011, 09:41:14 AM »
I cut the stub off the inner CV and weld this flange on to mount to gear box.
Logged
LiveWire
Guest
Re: CV, axle, hub, bearing pictures
«
Reply #4 on:
May 16, 2011, 09:42:43 AM »
I made some similar rings to do the 930 pattern. I did not put the holes in because the CV itself needs to be notched on the mill. I will do the holes at the same time.
Logged
Print
Pages: [
1
]
Go Up
« previous
next »
DTSFab.com (Desert, Trail and Sand)
»
Automotive Powered Off Road (AKA: Buggys, Jeeps, Trucks, Etc,Etc. )
»
Motor and Drivetrain
»
CV, axle, hub, bearing pictures
SimplePortal 2.3.7 © 2008-2024, SimplePortal