31
Everything Fabrication / Re: ABS Vacumn Forming
« Last post by fabr on December 10, 2018, 07:40:39 PM »Few pics. Vac motor is only 6" diamater and 8" high. Pretty impressive capabilities for it's size. Same one as has been used in some Superflow flow benches. One is of the abs in the heating frame,one is of the vac table and a couple showing red arrows where the holes sucked through. Both were in areas of no concern. I hope/believe the .125 won't have the issue. The wavy area of the part along the bottom of the pull all trims off so that is of no concern.