0 Members and 2 Guests are viewing this topic.
Could cut just the top part off the arms bolt to and widen it then brace and reweld it but it would not look as clean. Done ri. ght it might actually look pretty good.If I was looking at it right now I think I would put one each of the outside fixed arms on the outside of the frame and see how that was. If that did not float my boat then on to the next plan
hi Nutzyou certainly have your thinking head on machining the centre boss down by a 1/4" was an idea l was thinking of, and there is certainly enough meat on there to loose a bit as the pic shows,however l am determined to think ahead this time, how wide is a 2" die ? must be wider than the 1.5" that l have now l guess so chopping the centre boss down might stop me getting a 2" die at a latter dateputting a plate each side of the red frame has merit would give me 16mm if l did both sides or 8mm if l just did the one ? sounds the easiest ??would need new pins but thats no great problem is itAndy
Very nice indeed. Now to build something with it.
All you need now is a protractor on it and you got it!!!
well its just about finishedwill get some vid of it working