DTSFab.com (Desert, Trail and Sand)
Automotive Powered Off Road (AKA: Buggys, Jeeps, Trucks, Etc,Etc. ) => "AP" Member Project Logs => Topic started by: deranged on November 27, 2018, 09:42:38 AM
-
So I have gone back and forth with a new build...
I have this Hayabusa engine just sitting there staring at me every day....
My current car runs really well and is super reliable to boot. So I had this hair brained idea to just enjoy my single seat car the way it sits and then build a 2 seat chassis for the busa.. I did an initial layout as seen below. It kinda resembles the AR, but some refinements. I stretched it out to 120" wb, with an 80" track width in my layout....THEN, I got to measuring up a Subaru 2.0 or 2.5 engine and trans, and it looks as if I could make it a mid-engine, Subi powered car.
The Busa would then go into the single seat car for me to enjoy while I build the 2-seat car. ADD SUCKS!!!! LMAO
(https://i.imgur.com/YtoV3Jg.jpg)
(https://i.imgur.com/RfpR8rj.jpg)
(https://i.imgur.com/KWdMfJs.jpg)
(https://i.imgur.com/PKUzd7N.jpg)
(https://i.imgur.com/OeVsxxM.jpg)
Justin
-
Do the subi in the 2 seater and use the busa in the 1 seater. You won't be disappointed.
By the way,a new twist on C(ardboard) Aided Design :m C(oncrete) Aided Design!!! 8) 8)
-
wondered when this was coming! that is a very nice looking air cleaner! are you sure on turbo suby??
-
Do the subi in the 2 seater and use the busa in the 1 seater. You won't be disappointed.
What fabr said, it'll put a smile on your face! I do like the floor CAD layout
-
i do like the radius'd roof.
-
^^^^ yup
-
^^^^ What they said.