« previous next »
Pages: [1] 2   Go Down

Author Topic: Ski doo engine probelms  (Read 4810 times)

0 Members and 1 Guest are viewing this topic.

Bugpac

  • Guest
Ski doo engine probelms
« on: September 14, 2008, 06:20:44 PM »
My car pulsates under load, Im thinking it has an electrical issue, coil, ground etc? anyone experienced this problem before?
Logged

Bugpac

  • Guest
Re: Ski doo engine probelms
« Reply #1 on: September 16, 2008, 06:40:23 PM »
Bad fuel pump... ;D
Logged

VLADD

  • Guest
Re: Ski doo engine probelms
« Reply #2 on: September 17, 2008, 05:39:03 AM »
Can you just grab a rebuild kit from say like dennis kirk for 18 bux?
Logged

LiveWire

  • Guest
Re: Ski doo engine probelms
« Reply #3 on: September 17, 2008, 07:52:43 AM »
He got a whole new pump from me.
Logged

SPEC

  • Guest
Re: Ski doo engine probelms
« Reply #4 on: September 17, 2008, 07:57:08 AM »
BONUS
Logged

LiveWire

  • Guest
Re: Ski doo engine probelms
« Reply #5 on: September 17, 2008, 11:33:42 AM »
Did Spec get banned for pointing out mild steel brake rotors suck too? Or am I thinking of a different board. ;)
Logged

DuneBuggyDude

  • Guest
Re: Ski doo engine probelms
« Reply #6 on: September 18, 2008, 11:36:12 PM »
Logged

Admin

  • Guest
Re: Ski doo engine probelms
« Reply #7 on: September 19, 2008, 10:51:11 AM »
It is a 2 smoke, my jets are fine, one side of my fuel pump was just dribbling fuel, twin chamber pump, so when i accelerated hard one carb was running out of fuel...
Logged

SPEC

  • Guest
Re: Ski doo engine probelms
« Reply #8 on: September 20, 2008, 04:34:00 AM »
Quote from: LiveWire on September 17, 2008, 11:33:42 AM
Did Spec get banned for pointing out mild steel brake rotors suck too? Or am I thinking of a different board. ;)


WHAAA?
iI only got banned from SRYRAHOLE  for telling them they sucked ;D
Logged

LiveWire

  • Guest
Re: Ski doo engine probelms
« Reply #9 on: September 22, 2008, 04:31:14 PM »
Quote from: LiveWire on September 17, 2008, 11:33:42 AM
Did Spec get banned for pointing out mild steel brake rotors suck too? Or am I thinking of a different board. ;)
Quote from: SPEC on September 20, 2008, 04:34:00 AM

WHAAA?
iI only got banned from SRYRAHOLE  for telling them they sucked ;D

OK, then bug is the only one who has been banned from somewhere for that.
Logged

SPEC

  • Guest
Re: Ski doo engine probelms
« Reply #10 on: September 23, 2008, 08:28:51 AM »
But mild steel rotors do suck too ::)
I had some whipped up a while back on a cnc they worked okay for a short time but when they got hot for the 1st time they warped pretty bad, and pulsated after that...had they been thicker like 3/8" they might have been allright
Logged

LiveWire

  • Guest
Re: Ski doo engine probelms
« Reply #11 on: September 23, 2008, 11:27:05 AM »
These were for the rear of a Pilot. I think they are around 1/4" thick off the top of my head.
Logged

Admin

  • Guest
Re: Ski doo engine probelms
« Reply #12 on: September 23, 2008, 04:01:12 PM »
And they were not even p/o... ::)
Logged

tarmacblack

  • Guest
Re: Ski doo engine probelms
« Reply #13 on: September 24, 2008, 11:58:53 AM »
Logged

Admin

  • Guest
Re: Ski doo engine probelms
« Reply #14 on: September 24, 2008, 01:06:01 PM »
Those are like dinosaur...Now days they have float bowls and all just like anything else... ;D
Logged
Pages: [1] 2   Go Up
« previous next »
 
SimplePortal 2.3.7 © 2008-2024, SimplePortal