0 Members and 1 Guest are viewing this topic.
Side panels, starting to look like a car.
what is the aluminum container in front of the motor? I hope this fan placement works for you. I only say this because I tried this once and did not work, couldn't get 1 mile with out the motor running hot. nice pics!
I like the dash work!! nice job ..............your rail is looking good
I could only find 1 pic with a clear shot to show you but and this is only my opinion but I think you might need to add 2 more pieces of tube to the rear cradle support. from what I can see in the pic you have added all the bracing I would think you'll need except in one spot. looks good to btw! I know you have your muffler there and if you do add them you could even put a slight bend into them to clear the muffler imo.
That is the fuel cell. I hope the radiator works as well. I still haven't made up my mind how to control the fan. Let the Hayabusa turn it on and off or just add a temp switch.
When you had this configuration where you running a fan as well?
You need ,IMO,the temp sender to be in the factory location on the engine. You can do it that way using it to trigger a relay. The busa ECM likes to know the engine temp though.
you can use the factory circuit or what I like to use......enemy turned me on to these way back........http://www.speedwaymotors.com/Flex-A-Lite-31163-Temp-Sensitive-Variable-Speed-Control-Fan-Controller,60533.html .......I have used these on my v-6 rail and current busa rail.